
SW1-4
This switch is used to designate the FP's display mode.
SW1-6
This controls is used as the touch screen Click sound's ON/OFF switch.
When this is set to ON, a click will sound every time the touch panel is touched.
SW1-5
This switch controls the Automatic Backlight OFF mode.
When this switch is ON, and if there is no SIO transmission or touch operation performed for 5
minutes, the backlight turns off automatically. It will remain OFF until another SIO transmission or
touch operation takes place, at which time the backlight automatically turns back on.
If the FP unit is frequently not used, please set this switch ON to extend the life of the backlight.
Also, if a display related command is transmitted by the SIO, this Automatic Backlight OFF mode
will be automatically disabled.
For more details, refer to 4.'Analog RGB Interface'.
You can't use this switch on FP2600-T41.
Please set this switch OFF when the FP2600-T41 unit is used.
SW1-7
This is a switch to shift as adjustment mode at factory.
Please set this switch OFF when the FP unit is used.
SW1-4 Display Mode
OFF VGA Graphics & text mode
ON VGA Graphics mode
SW1-8
This is a switch to change the data input (command control) of the touch panel.
Data output and command input/output will be performed from the USB connector when this is ON
and from the RS232C connector when it is OFF.
4 Interfaces
Input signal type Analog RG B
InputsignalcharacteristicImagesignal:analog RG B
Synchronous signal:TTL level,negative true or
positive true
Scanning type:non-interlace
Setting by O SD (OnScreen
Display)
ContrastAdjustment
Sub ContrastAdjustment
Brightness A djustment
HorizontalDisplay Position Adjustment
VerticalDisplay P osition Adjustment
HorizontalAdjustment
Phase Adjustment
DimmerAdjustment
DefaultSetting (AllClearFunction)
Analog RGB Interface
Komentáře k této Příručce